Faculty of Science

Essential Qualifications:

(i) Good academic record having at least 55% marks (or an equivalent grade in a point scale wherever grading system is followed) at the Master’s Degree level in a relevant subject, from an Indian University, or an equivalent degree from an accredited foreign University.

(II) Besides fulfilling the above qualifications, the candidates must have cleared the National Eligibility Test (NET) conducted by the UGC, CSIR or similar test accredited by the UGC like SLET/SET.

(III) Notwithstanding anything contained in sub-clauses (i) and (ii) of clause 4.4.1 of UGC regulations 2010, candidates, who are, or have been awarded a Ph.D. Degree in accordance with the University Grants Commission (Minimum Standards and Procedure for Award of Ph.D. Degree) Regulations, 2009, shall be exempted from the requirement of the minimum eligibility condition of NET/ SLET/ SET for engagement of guest Teacher.

(IV) NET/ SLET/ SET shall also not be required for such Master’s Degree Programmes in discipline for which NET/ SLET/ SET is not conducted.

Application form along with detailed instructions can be downloaded from Tripura University website: www.tripurauniv.in. The duly filled in application forms complete in all respects may be sent so as to reach the Office of the Deputy Registrar Academic Branch, Tripura University, Suryamaninagar - 799022, Tripura on or before 31st July, 2014. The Candidates who responded against advertisement No. TU.REG/N-Advt./02/10 dated 20.02.2014 need not apply again.

For more info visit: http://www.tripurauniv.in/images/universitymedia/EmploymentNotification/Guest%20Teacher%20Advt.%20website_09072014.pdf

http://search.cpan.org/~lds/Bio-Graphics-2.37/

Address of the bookmark: http://search.cpan.org/~lds/Bio-Graphics-2.37/

About 8,000 years ago, the gene EGLN1 changed by a single DNA base pair. Today, a relatively short time later on the scale of human history, 88 percent of Tibetans have the genetic variation, and it was virtually absent from closely related lowland Asians. The findings indicate the genetic variation endows its carriers with an advantage.

In those without the adaptation, low oxygen caused their blood to become thick with oxygen-carrying red blood cells, an attempt to feed starved tissues, which could cause long-term complications such as heart failure. The researchers found that the newly identified genetic variation protected Tibetans by decreasing the over-response to low oxygen.

Reference: http://www.nature.com/nature/journal/v512/n7513/abs/nature13408.html

Address of the bookmark: https://saliweb.readthedocs.io/en/latest/frontend.html

No.of Posts:01 (SC)

Pay Scale:

Pay Band of Rs.15600-39100 + Rs.6000/- GP +NPA @ 25% of Basic Pay +Learning Resource Allowance @ Rs.20,000/-P.A.+ Conveyance Allowance @ Rs. 1650/-P.M.+ Academic Allowance @ Rs.2500/- P.M. and other admissible allowances.

Qualifications:

Area of Specialization:-

Bioinformatics/Computational/Biology/Genomics/ Proteomics/ Structural Biology

1. Postgraduate qualification, e.g. Master’s Degree in Biotechnology/Bioinformatics/ Biophysics.

2. A Doctorate Degree of recognized University/Institute in a basic or allied Medical Science subject e.g. Medical Biotechnology/Biophysics. Bioinformatics/X-ray Crystallography/

Immunology/Structural Biology etc

Experience:

1.Minimum three years teaching and/or research experience in a recognized medical/research Institution in an allied medical subject after obtaining doctorate degree and preferably in Medical

Molecular Biology/ Biophysics/Structural Biology/Genomics and Clinical Proteomics/Computational Biology.

2. Minimum two publication with atleast one in international journal and atleast one as first author

Desirable:-

Consistently excellent scholastic/academic record, demonstrated ability to write grant proposal/(s) successfully, Post Doctoral training in a frontier area of medical Bioinformatics Research and of direct relevance to clinical diagnosis or patient care (preferably from a recognized top-ranking medical institution abroad)

Send your applications to O/O, Deputy Registrar, Recruitment & Establishment Cell, University of Health Sciences, Rohtak by 08.7.2014

For more details,please visit website:http://pgimsrohtak.nic.in/2014%20AP%20Advt.pdf

➜ bloomfilter git:(master) ✗ swig -Wall -c++ -perl5 BloomFilter.i
➜ bloomfilter git:(master) ✗ g++ -c BloomFilter_wrap.cxx -I/home/urbe/anaconda3/lib/perl5/5.22.0/x86_64-linux-thread-multi/CORE/ -fPIC -Dbool=char -O3
BloomFilter_wrap.cxx:1892:30: fatal error: ../BloomFilter.hpp: No such file or directory
compilation terminated.
➜ bloomfilter git:(master) ✗ cd swig
➜ swig git:(master) ✗ g++ -c BloomFilter_wrap.cxx -I/home/urbe/anaconda3/lib/perl5/5.22.0/x86_64-linux-thread-multi/CORE/ -fPIC -Dbool=char -O3
In file included from BloomFilter_wrap.cxx:1877:0:
../BloomFilter.hpp: In member function ‘void BloomFilter::loadHeader(FILE*)’:
../BloomFilter.hpp:141:59: warning: ignoring return value of ‘size_t fread(void*, size_t, size_t, FILE*)’, declared with attribute warn_unused_result [-Wunused-result]
fread(&header, sizeof(struct FileHeader), 1, file);
^
➜ swig git:(master) ✗ g++ -Wall -shared BloomFilter_wrap.o -o BloomFilter.so -O3
➜ swig git:(master) ✗ cd ..
➜ bloomfilter git:(master) ✗ cd ..
➜ lib git:(master) ✗ cd ..
➜ bin git:(master) ✗ ./LINKS
Usage: ./LINKS [v1.8.6]
-f sequences to scaffold (Multi-FASTA format, required)
-s file-of-filenames, full path to long sequence reads or MPET pairs [see below] (Multi-FASTA/fastq format, required)
-m MPET reads (default -m 1 = yes, default = no, optional)
! DO NOT SET IF NOT USING MPET. WHEN SET, LINKS WILL EXPECT A SPECIAL FORMAT UNDER -s
! Paired MPET reads in their original outward orientation <- -> must be separated by ":"
>template_name
ACGACACTATGCATAAGCAGACGAGCAGCGACGCAGCACG:ATATATAGCGCACGACGCAGCACAGCAGCAGACGAC
-d distance between k-mer pairs (ie. target distances to re-scaffold on. default -d 4000, optional)
Multiple distances are separated by comma. eg. -d 500,1000,2000,3000
-k k-mer value (default -k 15, optional)
-t step of sliding window when extracting k-mer pairs from long reads (default -t 2, optional)
Multiple steps are separated by comma. eg. -t 10,5
-o offset position for extracting k-mer pairs (default -o 0, optional)
-e error (%) allowed on -d distance e.g. -e 0.1 == distance +/- 10% (default -e 0.1, optional)
-l minimum number of links (k-mer pairs) to compute scaffold (default -l 5, optional)
-a maximum link ratio between two best contig pairs (default -a 0.3, optional)
*higher values lead to least accurate scaffolding*
-z minimum contig length to consider for scaffolding (default -z 500, optional)
-b base name for your output files (optional)
-r Bloom filter input file for sequences supplied in -s (optional, if none provided will output to .bloom)
NOTE: BLOOM FILTER MUST BE DERIVED FROM THE SAME FILE SUPPLIED IN -f WITH SAME -k VALUE
IF YOU DO NOT SUPPLY A BLOOM FILTER, ONE WILL BE CREATED (.bloom)
-p Bloom filter false positive rate (default -p 0.001, optional; increase to prevent memory allocation errors)
-x Turn off Bloom filter functionality (-x 1 = yes, default = no, optional)
-v Runs in verbose mode (-v 1 = yes, default = no, optional)

Error: Missing mandatory options -f and -s.

ERROR fixed

perl: symbol lookup error: /home/urbe/Tools/LINKS_new/bin/./lib/bloomfilter/swig/BloomFilter.so: undefined symbol: Perl_Gthr_key_ptr

1.Stupid for biologist: Biology is so complex that it will make bioinformatician feel stupid. There are no any universal fixed rules; it can surprise you any time. So be nice to biologists who ask questions and resolve your biological puzzles. Sometime you will have no idea what the hell you were doing either.

2.Puzzling why: Do not hesitate to ask question. Especially. at the beginning of project you will have to ask a lot of questions. Instead of puzzling it out at end check out and clear your doubt even for a single error. It may can leads to wrong conclusion.

3.Running marathon: The most of the biological software’s documentation is always incomplete. In other word they are no more than 95 percent complete. Sometime a single problem can halt your entire project for months. Compilation and running the pipelines in tedious because almost all are interdependent and need proper configuration. I face the same kind of problem with Evolver :( …

4.Folders missing: The pipelines generate lots of data, and we keep them in several folders for future use. But sometime we delete them by mistake and move to recovery…

5.Digging deeper: Digging deeper is fruitful, but some time it can be catastrophic. You may get frustrated or direction less. So keep a biologist with you for rescue …. Sometime an expert computer programmer to handle your server. Remember, the server will always go down when you need it the most.

The most common frustrating  common line: Why do we do this again?

More at https://www.raku.org/

Address of the bookmark: https://www.raku.org/

The Bioinformatics and Systems Biology Unit of Université de Liège (Belgium) is looking for a highly motivated master student with programming skills for a PhD thesis project (4 years, fully funded) with the goal of designing computational tools that use literature, genomic and structural data in order to infer regulatory and metabolic networks.

Applicants are invited to send their resume and a recommendation letter to Prof. Patrick Meyer (more details at www.biosys.ulg.ac.be )

For more information : www.biosys.ulg.ac.be

More at https://bioinformaticsonline.com/snippets/view/42919/perl-ipcopen2-module

2. exec””

 syntax: exec "command";

3. Backticks “ or qx//

syntax: `command`;

syntax: qx/command/;

4. IPC::Open3

syntax: $output = open3(\*CHLD_IN, \*CHLD_OUT, \*CHLD_ERR, 'command arg1 arg2', 'optarg',...);

It is very similar to IPC::Open2 with the capability to capture all three file handles of the process, i.e., STDIN, STDOUT, and STDERR. It can also be used with or without the shell. You can read about it more in the documentation: IPC::Open3.

$output = open3(my $o ut, my $in, 'command arg1 arg2');

OR without using the shell

$output = open3(my $out, my $in, 'command', 'arg1', 'arg2');

5.a2p

syntax: a2p [options] [awkscript]

There is a Perl utility known as a2p which translates awk command to Perl. It takes awk script as input and generates a comparable Perl script as the output. Suppose, you want to execute the following awk statement

awk '{$1 = ""; $2 = ""; print}' f1.txt

This statement gives error sometimes even after escaping the variables (\$1, \$2) but by using a2p it can be easily converted to Perl script:

For further information, you can read it’s documentation: a2p

More help at https://bioinformaticsonline.com/snippets/view/42920/perl-script-to-run-awk-inside-perl

6. system()

syntax: system( "command" );

It is also a Perl function (perlfunc) that executes a command and waits for it to get finished first and then resume the Perl script. The return value is the exit status of the command. It can be called in two ways:

system( "command arg1 arg2" );

OR

system( "command", "arg1", "arg2" );

HELP

Here are some useful Perl cheat sheets that can be used as a quick reference guide.-- https://www.pcwdld.com/perl-cheat-sheet